X hits on this document

68 views

0 shares

0 downloads

0 comments

21 / 27

1005

TOILET GASKET

Take up the toilet and old seating gasket. Clean area and reseat toilet on a new wax gasket. Make all

connections and leave free of leaks. Install a water supply shut-off if none exists.

1006

TOILET SEAT

Install toilet seat with rustproof nylon hinges, plastic nuts and bolts. Must be UPC approved.

1007

TOILET REPAIR

Remove deteriorated flushing unit and install a new unit. Install all new seals with new flush unit. After replacement, unit shall function properly with moderate pressure and completely shut off when water level is reached. Install tankball or flapper and related parts as needed. Install a supply shut-off if none

exists.

1008

BATHTUB

Remove the existing tub from the job site including all piping that cannot be reused when installing new work. Furnish and install a new 60" Fiberglass recessed bathtub white. Must be UPC approved. Install

to code.

Variations of bathtub size or type may be called for in the bidder‟s specifications when

necessary. Work with the carpenter for enclosing the open end of the tub.

1009

BATHTUB SURROUND

Install a molded-engineered plastic, with a high gloss finish, three piece, and tub wall system above the bathtub. Panels of the system to be 56-60" high and have a molded soap dish in the center panel. All panels will be glued securely to a clean, dry, level surface with an adhesive recommended by the manufacturer. Color to be white unless agreed otherwise. Caulk panels according to manufacturer‟s

recommendation. Must be UPC approved.

1010

BATHTUB DOOR ENCLOSURE

Install tub enclosure sliding glass doors. Panels will be tempered glass with anodized aluminum frames and towel bars. Panels will glide on nylon rollers that fit into a self-draining track. Enclosure installation

will be adjustable for out-of-plumb walls. Caulk according to manufacturer‟s recommendation.

1011

BATHTUB CURTAIN/ROD ENCLOSURE

Install bath rod, curtain and liner. Owner to choose pattern & color of curtain & rod.

1012

ANTI-SCALD SHOWER FAUCET

Install anti-scald shower faucet when replacing plumbing for shower or replacing shower surround. Must

meet plumbing code.

1013

DRUM TRAP

Replace Drum trap on bathtub with appropriate new P-trap.

1014

LAVATORY

Install a new lavatory; remove existing fixture from job site, including all piping that cannot be reused when installing new work. Type to be vitreous china (wall type) white unless otherwise specified. Must be UPC approved. Install to code. Variations as to the size and type may be called for in the bidders

specifications when necessary. Quality and price to be mid-range.

\\citycr.local\sharedocs\PublicWorks\HSG\Housing Rehab\Specs-Codes\General Specifications.doc

21

Document info
Document views68
Page views68
Page last viewedSat Dec 10 22:28:29 UTC 2016
Pages27
Paragraphs935
Words10325

Comments