X hits on this document

182 views

0 shares

0 downloads

0 comments

25 / 74

SPC-1 BENCHMARK EXECUTION RESULTS PRIMARY METRICS TEST – SUSTAINABILITY TEST PHASE

Page 25 of 74

Primary Metrics Test – Sustainability Test Phase Clause 5.4.4.1.1

The Sustainability Test Phase has exactly one Test Run and shall demonstrate the maximum sustainable I/O Request Throughput within at least a continuous three (3) hour Measurement Interval. This Test Phase also serves to insure that the TSC has reached Steady State prior to reporting the final maximum I/O Request Throughput result (SPC-1 IOPS™).

Clause 5.4.4.1.2

The computed I/O Request Throughput of the Sustainability Test must be within 5% of the reported SPC-1 IOPS™ result.

Clause 5.4.4.1.4

The Average Response Time, as defined in Clause 5.1.1, will be computed and reported for the Sustainability Test Run and cannot exceed 30 milliseconds. If the Average Response time exceeds that 30-milliseconds constraint, the measurement is invalid.

Clause 9.4.3.7.1 For the Sustainability Test Phase the FDR shall contain:

  • 1.

    A Data Rate Distribution graph and data table.

  • 2.

    I/O Request Throughput Distribution graph and data table.

  • 3.

    A Response Time Frequency Distribution graph and table.

  • 4.

    An Average Response Time Distribution graph and table.

  • 5.

    The human readable Test Run Results File produced by the Workload Generator (may be included in an appendix).

  • 6.

    A listing or screen image of all input parameters supplied to the Workload Generator (may be included in an appendix).

  • 7.

    The Measured Intensity Multiplier for each I/O stream.

  • 8.

    The variability of the Measured Intensity Multiplier, as defined in Clause 5.3.13.3.

SPC-1 Workload Generator Input Parameters

The SPC-1 Workload Generator input parameters for the Sustainability, IOPS, Response Time Ramp, Repeatability, and Persistence Test Runs are documented in “Appendix E: SPC-1 Workload Generator Input Parameters” on Page 73.

Sustainability Test Results File

A link to the test results file generated from the Sustainability Test Run is listed below. Sustainability Test Results File

SPC BENCHMARK 1™ V1.12

FULL DISCLOSURE REPORT

Huawei Symantec Technologies Co., Ltd. Huawei Symantec Oceanspace™ S8100 (8-node)

Submission Identifier: A00099 Submitted for Review: NOVEMBER 11, 2010

Document info
Document views182
Page views182
Page last viewedSun Dec 04 04:44:03 UTC 2016
Pages74
Paragraphs6246
Words21133

Comments