X hits on this document

PDF document

Changing Entertainment. Again. - page 13 / 68





13 / 68

Connections and Setup

Install Batteries in the Remote

  • 1.

    Remove the battery compartment cover on the back of the remote.

  • 2.

    Insert new batteries. Match the polarities (+ and –) on the batteries with the diagram on the

remote. 3. Put the battery compartment cover back on the remote.

Important Battery Information

  • If you’re not going to use the remote for a month or more, be sure to remove the batteries because they can leak and cause damage.

  • Dispose of batteries in the proper manner, according to federal, state, and local regulations.

  • Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all batteries are not replaced at the same time, if disposed of in fire, or if an attempt is made to charge a battery not intended to be recharged.

  • Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.

Point the Remote in the Right Direction and Put it in DVD or VCR Mode

When you want the remote to operate the DVD/VCR player, point the remote at the DVD/VCR, not the TV. The remote has to be pointed in the correct direction and toward the correct component in order for the remote control’s signal to communicate with the sensor on the component. Make sure there is a clear path between the remote control and the component you want to operate, so the signal isn’t blocked.

Turn on the TV and DVD/VCR

  • 1.

    Turn on your TV and tune it to the correct Video Input Channel.

    • If you used a coaxial cable to connect your DVD/VCR to your TV, tune the TV to channel 3. Your TV must be set to channel 3 the first time you set up the DVD/VCR. See page 37 for instructions on how to change the ouput channel once you have started setup.

    • If you used audio/video cables to connect your DVD/VCR, tune the the TV to its Video Input Channel (see page 62 for help).

  • 2.

    Press the DVD or VCR button to turn on the DVD/VCR.

    • For DVD functions, press the DVD button.

    • For VCR functions, press the VCR button.

3. The first time you turn on your DVD/VCR, the Languages menu appears.

If you want the DVD/VCR menus to appear in English, press the OK button on the remote control. If you prefer another language, press the arrow down button until that language is highlighted. Press OK to select the language.

The Languages menu.

Chapter 1


Document info
Document views127
Page views127
Page last viewedWed Oct 26 15:44:42 UTC 2016