X hits on this document

PDF document

Cisco AVVID Network Infrastructure IP Multicast Design - page 74 / 98

235 views

0 shares

0 downloads

0 comments

74 / 98

Chapter 6

IP Multicast in a Site-to-Site VPN

VPN Deployment Model

Head-End

Following is the configuration that applies the crypto maps for VPN-HE-1.

interface FastEthernet0/1 description to ISP for VPN ip address 131.108.1.1 255.255.255.252 crypto map static-map ! interface Tunnel0 description Primary Tunnel to Branch1 ip address 10.200.1.1 255.255.255.252 tunnel source FastEthernet0/1 tunnel destination 131.108.101.1 crypto map static-map ! interface Tunnel1 description Secondary Tunnel to Branch2 ip address 10.200.1.13 255.255.255.252 delay 6000 tunnel source FastEthernet0/1 tunnel destination 131.108.102.1 crypto map static-map

Following is the configuration that applies the crypto maps for VPN-HE-2.

interface FastEthernet0/1 description to ISP for VPN ip address 131.108.1.5 255.255.255.252 crypto map static-map ! interface Tunnel0 description Primary Tunnel to Branch2 ip address 10.200.1.9 255.255.255.252 tunnel source FastEthernet0/1 tunnel destination 131.108.102.1 crypto map static-map ! interface Tunnel1 description Secondary Tunnel to Branch1 ip address 10.200.1.5 255.255.255.252 delay 6000 tunnel source FastEthernet0/1 tunnel destination 131.108.101.1 crypto map static-map

Note

EIGRP is the routing protocol used in this design. See the Cisco AVVID Network Infrastructure Enterprise Site-to-Site VPN Design SRND for alternative ways to influence cost in other IGP routing protocols.

Cisco AVVID Network Infrastructure IP Multicast Design

6-10

956651

Document info
Document views235
Page views235
Page last viewedThu Dec 08 15:18:32 UTC 2016
Pages98
Paragraphs2650
Words25637

Comments