X hits on this document

PDF document

Cisco AVVID Network Infrastructure IP Multicast Design - page 75 / 98

211 views

0 shares

0 downloads

0 comments

75 / 98

Chapter 6

IP Multicast in a Site-to-Site VPN

VPN Deployment Model

Branch

Following is the configuration that applies the crypto maps for VPN-Branch-1.

interface Serial0/0 description to ISP for VPN ip address 131.108.101.1 255.255.255.252 crypto map static-map ! interface Tunnel0 description Primary Tunnel to HE1 ip address 10.200.1.2 255.255.255.252 tunnel source Serial0/0 tunnel destination 131.108.1.1 crypto map static-map ! interface Tunnel1 description Secondary Tunnel to HE2 ip address 10.200.1.6 255.255.255.252 delay 60000 tunnel source Serial0/0 tunnel destination 131.108.1.5 crypto map static-map

Following is the configuration that applies the crypto maps for VPN-Branch-2.

interface Serial0 description to ISP for VPN ip address 131.108.102.1 255.255.255.252 crypto map static-map ! interface Tunnel0 description Primary Tunnel to HE2 ip address 10.200.1.10 255.255.255.252 tunnel source Serial0 tunnel destination 131.108.1.5 crypto map static-map ! interface Tunnel1 description Secondary Tunnel to HE1 ip address 10.200.1.14 255.255.255.252 delay 60000 tunnel source Serial0 tunnel destination 131.108.1.1 crypto map static-map

Static Route Configuration

At a minimum, each router must have a static host route for each for the other end-point. The head-end peers (primary and secondary) will point to ISP as the gateway to reach the branches. And the branches will point back to the ISP as the gateway to reach the head-end routers.

Cisco AVVID Network Infrastructure IP Multicast Design

956651

6-11

Document info
Document views211
Page views211
Page last viewedMon Dec 05 07:54:49 UTC 2016
Pages98
Paragraphs2650
Words25637

Comments