X hits on this document

PDF document

Cisco AVVID Network Infrastructure IP Multicast Design - page 79 / 98

364 views

0 shares

0 downloads

0 comments

79 / 98

Chapter 6

IP Multicast in a Site-to-Site VPN

Summary

Following is the basic multicast configuration for VPN-HE-2.

ip multicast-routing ! interface Tunnel0

description Primary Tunnel to Branch2 ip pim sparse-mode ! interface Tunnel1

description Secondary Tunnel to Branch1 ip pim sparse-mode ! interface FastEthernet0/0

description to Corporate Network ip pim sparse-mode ! ip pim rp-address 10.6.2.1

Loopback 1 address of both RPs.

Note

Ensure that the IP subnets for the GRE tunnels are advertised in the IGP routing protocol. If not, RPF failures will occur.

Summary

In summary, when using IP multicast with MoH or IP/TV in the WAN follow these recommendations. Use PIM-SM (recommended) Anycast RP (recommended) Fast convergence, redundancy, load balancing

Cisco AVVID Network Infrastructure IP Multicast Design

956651

6-15

Document info
Document views364
Page views364
Page last viewedMon Jan 23 19:11:46 UTC 2017
Pages98
Paragraphs2650
Words25637

Comments