X hits on this document

PDF document

MATERIAL SAFETY DATA SHEET ADAMS ELEVATOR HYD. OIL HD 46 - page 2 / 5

12 views

0 shares

0 downloads

0 comments

2 / 5

10129 - ADAMS ELEVATOR HYD. OIL HD 46

ROUTE OF ENTRY: Inhalation. Skin and/or eye contact. Ingestion.

4. FIRST AID MEASURES

INHALATION:

Vapor inhalation under ambient conditions is normally not a problem. If overcome by vapor of hot product, immediately remove from source of exposure. Get medical attention if any discomfort continues. For breathing difficulties oxygen may be necessary.

INGESTION:

DO NOT INDUCE VOMITING! Remove victim immediately from source of exposure. Get medical attention immediately! Never give anything by mouth to an unconscious person.

SKIN:

Remove contaminated clothing. Wash skin thoroughly with soap and water. Contact physician if irritation persists.

EYES:

Important! Immediately rinse with water for at least 15 minutes. Contact physician if irritation persists.

5. FIRE FIGHTING MEASURES

FLASH POINT (°F):

~415

FLAMMABILITY LIMIT - LOWER(%):

0.9

FLAMMABILITY LIMIT - UPPER(%):

7.0

METHOD: Cd OC (Cleveland open cup).

EXTINGUISHING MEDIA: Use: Alcohol resistant foam. Dry chemicals, sand, dolomite etc. Carbon dioxide (CO2).

SPECIAL FIRE FIGHTING PROCEDURES: Use water spray to keep fire exposed containers cool and disperse vapors. Water spray may be used to flush spills away from exposures. Caution should be exercised when using water or foam as frothing may occur.

UNUSUAL FIRE & EXPLOSION HAZARDS: Pressure will increase in over heated, closed containers.

HAZARDOUS COMBUSTION PRODUCTS: Acrid smoke/fumes. Oxides of: Carbon.

PROTECTIVE MEASURES IN CASE OF FIRE: Self-contained breathing equipment and chemical resistant clothing recommended.

6. ACCIDENTAL RELEASE MEASURES

PERSONAL PRECAUTIONS: Minimize skin contact.

PRECAUTIONS TO PROTECT THE ENVIRONMENT: Keep product out of sewers and watercourses by diking or impounding. Advise authorities if product has entered or may enter sewers, watercourses or extensive land areas. Assure conformity with applicable government regulations.

SPILL CLEAN-UP PROCEDURES: Contain spill. Neutralize and absorb small amounts. Collect and return large amounts to shipping container. Rinse spill area with water.

7. HANDLING AND STORAGE

2/5

Document info
Document views12
Page views12
Page last viewedFri Dec 02 22:53:37 UTC 2016
Pages5
Paragraphs169
Words1317

Comments