X hits on this document

30 views

0 shares

0 downloads

0 comments

11 / 18

Gateway Installation and Support Guide

Installing the Gateway and USB Driver on Macintosh Computers Running OS 10.2

Before making your USB connection to the gateway, you must install the 2Wire gateway USB driver on your computer. The following instructions are for USB installation on Macintosh computers running OS 10.2.

1.

With your computer powered on and the 2Wire Setup Wizard CD still in the CD-ROM drive, double-click the 2Wire CD icon on your desktop.

2.

Double-click 2Wire USB to begin the driver installation.

3.

If you have set up an administrator name and password, the Authenticate screen opens. Enter your administrator name and password and click OK.

4.

Follow the on-screen instructions. When the driver installation is complete, you will be prompted to restart your computer.

5.

After your computer restarts, connect the provided blue USB cable from the USB port on the 2Wire gateway to your computer's USB port. A USB port is identified by the following icon:

6.

Open the network Control Panel and select the Apple icon > System Preferences… > Network.

7.

Verify that Ethernet Adapter (en1) is selected in the Show field. If not, select it from the pull-down menu. When the New Port Detected message displays, click OK.

Note: Your Macintosh computer usually names the gateway USB port as (en1) automatically. If your computer has more than one Ethernet-like network device installed, the USB port may be names (en2) or higher.

IMPORTANT: Restart the 2Wire Setup Wizard CD to resume your installation process:

Double-click on the 2Wire CD icon.

Double-click the 2Wire Setup Wizard icon and follow the on-screen instructions to configure your gateway to the Internet.

8.

Click Save to complete your installation.

9.

9

Document info
Document views30
Page views30
Page last viewedFri Oct 28 19:59:48 UTC 2016
Pages18
Paragraphs293
Words3486

Comments