X hits on this document

39 views

0 shares

0 downloads

0 comments

18 / 18

Gateway Installation and Support Guide

Appendix E: Back-Up Key Codes

In most cases, you will receive a key code from your ISP. This key code is used to activate the 2Wire gateway. If you did not receive a key code, you can use the key codes provided in the following table.

If your Internet Service Provider gave you a PPPoE username and password to set up your Internet connection, your broadband connection uses Point- to-Point Protocol over Ethernet and you should use this key code.

52EU-2374-6262-22AS-B22Y

If your Internet Service Provider assigned you an IP address to set up your Internet connection, your broadband connection uses static IP (Internet Protocol) and you should use this key code.

52EU-2374-2E66-22AS-B2TW

If your Internet Service Provider did not provide you with a user name, password, or IP address to set up your Internet connection, your broadband connection most likely uses DHCP (Dynamic Host Configuration Protocol) and you should use this key code.

52EU-2374-2262-22AT-B222

16

Document info
Document views39
Page views39
Page last viewedWed Dec 07 11:23:47 UTC 2016
Pages18
Paragraphs293
Words3486

Comments