X hits on this document

35 views

0 shares

0 downloads

0 comments

3 / 18

Installing and Configuring the Gateway

Windows 98/SE/2K/ME/XP and Macintosh OS 10.2

Congratulations on the purchase of your 2Wire gateway. To install your gateway and configure your home network, follow these steps.

Note: Features for different models may vary. Product details will be specified for each particular model.

Note: TO MAC OS 9.X AND OTHER OPERATING SYSTEM USERS: Users running Mac OS 9.X and operating systems other than those stated above must perform a manual configuration of the gateway. Refer to Appendix C for step-by-step instructions.

Insert the 2Wire Setup Wizard CD and follow the on-screen instructions

Do NOT install any equipment until instructed by the CD during your installation.

Enter key code

If you were provided with a 20-digit key code by your service provider, enter it when prompted. If you were not provided with a key code, refer to “Appendix E: Back-Up Key Codes” on page 16.

Add computers to your network

Insert the 2Wire Setup Wizard CD into the CD-ROM drive of each computer that you wish to connect to your network and follow the on-screen instructions.

1

Document info
Document views35
Page views35
Page last viewedMon Dec 05 21:28:09 UTC 2016
Pages18
Paragraphs293
Words3486

Comments