X hits on this document

138 views

0 shares

0 downloads

0 comments

10 / 45

TOYOTA Procedure

Fig 5-4

Fig 5-5

Fig 5-6

Fig 5-7

Issue: B

10/20/07

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

(b) Disconnect the 6 fuel injector connectors. Remove the 6 bolts and fuel delivery pipe together with the 6 fuel injectors (Figs 5-1 & 5-4).

(c) Pull the 6 injectors out of the delivery pipe (Fig 5-5). Discard the injectors as they will be replaced with new higher flow injectors. The old injectors should be saved for the customer.

NOTE: The new injectors (K3) have Mustard colored bodies, while the old injectors have Blue colored bodies.

(d) Install a light coat of spindle oil or gasoline to the O-ring on the top of each new injector. While turning the fuel injector left or right, install it onto the fuel delivery pipe positioning the connector facing outward (Fig 5-6). Repeat for all six new injectors.

  • (e)

    Place the fuel delivery pipe together with the new injectors on the intake manifold. Provisionally install the 6 bolts, which are used to hold the delivery pipe, onto the intake manifold. Check to see that the injectors rotate smoothly. Position the injector connectors facing outward. Tighten the 6 bolts. Torque: 15 Nm (11 ft lbf) (Fig 5-7).

  • (f)

    Reconnect the 6 fuel injector connectors.

Page 10 of 45 pages

Document info
Document views138
Page views139
Page last viewedSat Dec 03 05:02:55 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments