X hits on this document

136 views

0 shares

0 downloads

0 comments

12 / 45

TOYOTA Procedure

FJ CRUISER

Old Plug

New Plug

Fig 6-4

Fig 7-3

Issue: B

10/20/07

MY – 2007-

SUPERCHARGER FIT KIT

(d) Install the 6 new spark plugs (K2). A little anti-seize on the plug threads will prevent seizing in the future (Fig 6-4). Torque: 20 Nm (15 ft lbf)

Set Spark Plug Gap at 0.8 mm (0.032”)

(e) Reinstall the ignition coils and the bolts. Torque: 10 Nm (7.4 ft lbf)

  • 7.

    Coolant, Fan and Shroud Removal.

    • (a)

      Remove the 7 plastic clips from the black plastic seal cover at the top of the radiator and set it aside for reinstallation later (Fig 7-1).

Fig 7-1

(b) Remove 4 bolts, then remove the No.1 engine under cover (Fig 7-2).

Fig 7-2

  • (c)

    Drain Engine Coolant CAUTION: To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

    • i.

      Remove the service hole cover from the engine under cover. NOTE: On some vehicles it may be necessary to remove the skid plate.

ii. Install a vinyl hose onto the drain on the radiator side (Fig 7-3) and secure with tape.

Page 12 of 45 pages

Document info
Document views136
Page views137
Page last viewedSun Oct 30 02:06:53 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments