X hits on this document

164 views

0 shares

0 downloads

0 comments

13 / 45

TOYOTA Procedure

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

iii. Loosen the three drain plugs on the engine and radiator and drain the coolant into a clean container (Fig 7-4). Save the coolant as it will be reused.

Fig 7-4

    • iv.

      Remove the radiator cap.

    • v.

      Drain the coolant from the reservoir tank.

    • vi.

      Tighten the three drain plugs. Torque: 13 Nm (9.0 ft lbf) for the engine

    • vii.

      Remove the vinyl hose from the radiator.

  • (d)

    Remove the top radiator hose (Fig 7-5). Save

for reuse.

Fig 7-5

(e) Remove the four nuts that attach the fan/clutch to the fan pulley (Fig 7-6). Leave the fan in place for now.

Fig 7-6

(f) Remove the two bolts from the top corners of the fan shroud (Fig 7-7) and the bottom corner of the coolant overflow tank.

Fig 7-7

(g) Disconnect the coolant overflow tube from the radiator (Fig 7-5). If the vehicle has an oil cooler, it will be necessary to remove a clip holding the fluid lines to the shroud.

Issue: B

10/20/07

Page 13 of 45 pages

Document info
Document views164
Page views165
Page last viewedWed Dec 07 12:52:59 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments