X hits on this document

169 views

0 shares

0 downloads

0 comments

16 / 45

TOYOTA Procedure

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

(h) Install the supplied crankshaft pulley (E1) in front of the existing crankshaft pulley making certain that the dowel pin in the new pulley is aligned with the key way in the existing pulley using the new supplied bolt (E2) and washer (E3) (Fig 8-7). Torque: 277 Nm (204 ft lbf)

Fig 8-7

SST 09213-54015 and SST 09330-00021

(i) Install the blower drive belt (C2) as shown (Fig 8-8).

Fig 8-8

  • 9.

    Installation of the Auxiliary Tensioner Assembly.

    • (a)

      Remove the 2 M10 nuts and then install the belt tensioner assembly (C1) onto the two double ended studs previously installed (Fig 9-1 & 9-2). Make sure both sides of the blower drive belt are free between the tensioner pulley and the upper idler pulley. Reinstall the two M10 nuts (C7) finger tight.

Fig 9-1

Fig 9-2

Issue: B

10/20/07

Page 16 of 45 pages

Document info
Document views169
Page views170
Page last viewedWed Dec 07 22:32:15 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments