X hits on this document

173 views

0 shares

0 downloads

0 comments

17 / 45

TOYOTA Procedure

Fig 9-2

Fig 9-4

Fig 10-1

Fig 10-2

Issue: B

10/20/07

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

(b) Remove the top/forward AC compressor mounting bolt (Fig 9-3). CAUTION: Do not remove the bolts that attach the AC lines to the compressor.

    • (c)

      Using the bolt removed in step 9-b, attach one end of the tensioner support bracket (C5) to the AC compressor finger tight (Fig 9-4). NOTE: Notice that the bracket goes behind the belt.

    • (d)

      Attach the other end of the strut bracket to the belt tensioner bracket using an M8x16 bolt (C8) (Fig 9-4). Tighten the two M10 nuts, then M8x16 bolt, and finally the AC Compressor bolt. Torque: 39 Nm (29 ft lbf) for M10 nuts Torque: 25 Nm (18 ft lbf) for M8 bolts

    • (e)

      Be sure the blower drive belt is on the bottom of the tensioner pulley (Fig 9-1).

  • 10.

    Installation of the Water Manifold Spacers.

    • (a)

      Remove 2 throttle body bypass hoses, 2 small bypass hoses, and the larger bypass hose that are attached to the thermostat water manifold (Fig 10-1). It is suggested that a diagram be made showing where all the hoses go. Some vehicles may also have 2 oil cooler hoses to remove.

    • (b)

      Remove and discard the 5 bolts attaching the thermostat water manifold to the engine. Make sure the 2 O-rings remain on the engine (Fig 10-2).

Page 17 of 45 pages

Document info
Document views173
Page views174
Page last viewedSat Dec 10 00:16:41 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments