X hits on this document

143 views

0 shares

0 downloads

0 comments

20 / 45

TOYOTA Procedure

Fig 11-2

Fig 12-1

Fig 13-2

Issue: B

10/20/07

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

(b) Make certain that the metal bracket is not attached to either the heater hoses or the wiring harness (Fig 11-2).

  • 12.

    Installation of the Support Bracket

    • (a)

      On the driver’s side (left) of the engine, remove the rear intake manifold support bracket (surge tank stay No. 2) and replace it with the new support bracket (F1) (Fig 12-1). Note: the original bracket is stamped with a “C” and the new bracket is stamped with a “B”. Leave the attaching bolt finger tight. Make sure you use the same threaded bolt hole on the engine.

  • 13.

    Installation of the Vacuum Switching Valve (VSV) Assembly and Hoses.

    • (a)

      Remove the VSV from the left rear side of the original intake manifold (surge tank) (Fig 13-1). Keep the VSV and bolt for the next step.

Fig 13-1

  • (b)

    Attach the VSV to the supplied VSV Bracket (F3) using the stock bolt and a supplied M6 nut (F4) (Fig 13-2).

  • (c)

    Mount the VSV/VSV bracket subassembly to the front stud of the oil filler cap housing. Remove the stock nut, install the M6 washer (F5), the bracket-valve assembly, and reinstall the nut (Fig 13-2). Torque: 9 Nm (80 in lbf)

Page 20 of 45 pages

Document info
Document views143
Page views144
Page last viewedSat Dec 03 22:21:28 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments