X hits on this document

215 views

0 shares

0 downloads

0 comments

24 / 45

TOYOTA Procedure

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

Fig 15-4

Idler

Tensioner

Crank Pulley

Supercharger Pulley

(f) After checking to make certain the large O- ring is properly seated in the groove in the main housing, carefully re-install the supercharger housing top cover by lowering it straight down. Fasten with the original 12 M6 bolts. Torque: 12 Nm (9 ft lbf) CAUTION: If the O-ring ends have separated, place a small spot of black RTV over the area where they join before placing the lid in position.

Idler

(g) Finish installing the supercharger belt drive making sure the routing is correct (Fig 15-4).

  • 16.

    Installation of the Fan and Shroud Assembly, Hoses and Throttle Body.

    • (a)

      Re-install the fan and radiator shroud and tighten all fasteners. Torque: 21 Nm (15 ft lbf) fan nuts Torque: 5 Nm (44 in lbf) shroud bolts

    • (b)

      Re-install the top radiator hose.

    • (c)

      Install the throttle body to the supercharger housing and re-connect the coolant hoses to the thermostat water manifold (Fig 16-1). Torque: 11 Nm (8 ft lbf)

Fig 16-1

(g) Using the new screw clamps, install the new lower radiator hose (K1) (Fig 16-2). CAUTION: Turn the clamps so they do not hit the fan.

Fig 16-2

Issue: B

10/20/07

Page 24 of 45 pages

Document info
Document views215
Page views216
Page last viewedSat Jan 21 03:00:22 UTC 2017
Pages45
Paragraphs1344
Words8482

Comments