X hits on this document

145 views

0 shares

0 downloads

0 comments

31 / 45

TOYOTA Procedure

90° Tab

Fig 19-5

Issue: B

10/20/07

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

  • (d)

    Attach the reservoir bracket brace (A3) to the threaded hole where the bolt was removed in step 19c using the M8x20 bolt (A6) (Fig 19-

    • 4)

      . Torque: 8 Nm (71 in lbf) The other end of the brace will attach to the upper driver’s side hole in the reservoir bracket when the reservoir is mounted.

Fig 19-4

(e) Using 3 M6x12 bolts (H14), mount the intercooler reservoir tank (I2) to the reservoir bracket (Fig 19-4) making sure you capture the brace from step 19b. Torque: 4 Nm (35 in lbf)

FOR AUTOMATIC TRANSMISSIONS

  • (f)

    There will either be an open M8 threaded hole in the driver’s side inner fender panel, or it may have a tab on a bracket in the threades hole as shown (Fig 19-5).

  • (g)

    If the bracket is present, remove and flatten the tab as shown (Fig 19-6).

Fig 19-7

  • (h)

    Attach the reservoir bracket brace (A3) to the threaded hole using the M8x20 bolt (A6) (Fig 19-4). Torque: 8 Nm (71 in lbf) The other end of the brace will attach to the upper driver’s side hole in the reservoir bracket when the reservoir is mounted (Fig 19-7).

  • (i)

    Remount the bracket as shown (Fig 19-7).

(j) Using 3 M6x12 bolts (H14), mount the intercooler reservoir tank (I2) to the reservoir bracket (Fig 19-4) making sure you capture the brace from step 19h. Torque: 4 Nm (35 in lbf)

Page 31 of 45 pages

Document info
Document views145
Page views146
Page last viewedSun Dec 04 06:15:33 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments