X hits on this document

179 views

0 shares

0 downloads

0 comments

33 / 45

TOYOTA Procedure

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

Fig 19-12

(o) Trim the hose to length and secure it to the pump inlet with a wide band spring clamp (H3) (Fig 19-13). Keep the trimmed hose length for the next steps.

(p) Take the remaining 1” wire loom (J1) and cut it into 36”, 18”, and 6” lengths.

Inlet

(q) Take the 4” x 60” molded coolant hose (J3) and cut short 4” leg as shown in (Fig 19-14). Place the 18” length of 1” split wire loom on this hose so it starts approximately 12” from the short leg. Slide a wide band spring clamp (H3) approximately 2” on from the long end of this hose. Use the straight hose mender (H5) to secure it to the remaining piece of ¾hose from step 19n. Secure with the wide band spring clamps (H3). Slide the 36” length of split loom onto this hose assembly.

Fig 19-14

(r) This new hose assembly will be routed from the intercooler inlet (Fig 19-15), behind the brake master cylinder (Fig 19-16), along the inner fender panel, through the hole in the radiator side support (Fig 19-12), and to the LTR outlet (Fig 19-16).

Outlet

Fig 19-13

4” X 60” Hose

Cut & discard end of hose.

Fig 19-15

  • (s)

    Install the short leg of the molded hose end to the passenger side intercooler fitting on the supercharger housing top cover (Fig 19-

    • 15)

      . Secure it with the wide band spring

clamp.

Issue: B

10/20/07

Page 33 of 45 pages

Document info
Document views179
Page views180
Page last viewedSun Dec 11 01:06:02 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments