X hits on this document

137 views

0 shares

0 downloads

0 comments

35 / 45

TOYOTA Procedure

Fig 19-20

Fig 19-21

Fig 19-22

Fig 20-1

Issue: B

10/20/07

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

(w) Run the hose along the earlier hose to the inlet on the reservoir. After shaping the Unicoil to hold the hose shape, trim the remaining end as necessary, and install it on the inlet nipple of the intercooler reservoir with the screw clamp (H6) (Fig 19-20).

(x) Using the small Adel clamp (H7) and a M6X12 bolt (H14), secure the two coolant hoses to the boss on the rear of the supercharger housing (Fig 19-21).

(y) Finally, place the 6” length of split wire loom over the Unicoil to keep it from scratching the paint (Fig 19-22)

  • 20.

    Installation of the Intercooler Pump Relay Harness.

    • (a)

      Using the supplied M6x20 bolt (H8) and hex nut (H9), mount the intercooler relay harness (H1) on the rear of the radiator support bulkhead using an existing open hole (Fig 20-1). NOTE: The bolt diameter is slightly larger than the hole in the relay. You can either drill out the hole in the relay with a 6 mm drill or just screw the bolt into the relay mounting hole. Drilling is easier.

Page 35 of 45 pages

Document info
Document views137
Page views138
Page last viewedSat Dec 03 01:09:39 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments