X hits on this document

228 views

0 shares

0 downloads

0 comments

36 / 45

TOYOTA Procedure

Fig 20-2

Fig 20-3

Issue: B

10/20/07

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

(b) Remove the bolt retaining the vehicle ground wire to the fender, take the ground wire from the intercooler pump relay and install it over the vehicle ground wire and reinstall the bolt (Fig 20-2).

(c) Route the two wire connector through the opening in the radiator support bulkhead (Fig 20-3).

(d) Plug the two wire connector into the intercooler pump (Fig 20-4). Secure the extra wire with tie-wraps (H4).

Fig 20-4

(e) Route the wire harness containing the 10 gauge red wire and the yellow wire along the front of the fuse panel from the fender to the inside of the fuse box (Fig 20-5). Note: the battery is removed for clarity in the figure. Feed both wires up into the fuse box through the same opening used by the vehicle wiring harness.

Fig 20-5

Page 36 of 45 pages

Document info
Document views228
Page views229
Page last viewedTue Jan 24 17:19:25 UTC 2017
Pages45
Paragraphs1344
Words8482

Comments