X hits on this document

168 views

0 shares

0 downloads

0 comments

41 / 45

TOYOTA Procedure

Fig 23-1

Issue: B

10/20/07

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

(d) Slowly pour coolant into the radiator reservoir until it reaches the FULL line.

    • (e)

      Fill the intercooler reservoir with the same coolant as the vehicle radiator.

    • (f)

      Reinstall and connect the battery.

    • (g)

      Once the reservoir is full and will not take any more coolant, turn the ignition key to on, but do not start the engine. This will cause the intercooler pump to run and purge air from the intercooler system. Continue to add coolant to the reservoir until it is full.

    • (h)

      Place the new vacuum and belt routing label (L8) on an open area under the hood. DO NOT cover the original vacuum hose label. Place the CARB OE Emissions label (L9) near the vacuum and belt routing label (Fig 23-1). Clean the area of any dirt and contaminants before adhering the labels.

    • (i)

      Install the Premium Fuel Only decals (L3). Place one on the dash near the fuel gauge AND one near the fuel filler cap.

  • 24.

    ECU Re-flash

    • (a)

      The proper procedure to re-flash the ECU (Engine Control Unit) is explained in a Technical Service Bulletin (SS002-07) titled “Techstream ECU Flash Reprogramming Procedure” located on T.I.S. (Toyota Information System).

    • (b)

      Download your correct vehicle ECU Calibration Update from TIS (See chart below) into the Techstream Tool using the TIS Calibration Update Wizard.

Page 41 of 45 pages

Document info
Document views168
Page views169
Page last viewedWed Dec 07 20:52:22 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments