FJ Cruiser 4WD M/T
FJ Cruiser 2WD, 4WD A/T
MY – 2007-
SUPERCHARGER FIT KIT
Target Calibration ID
Supercharger Calibration ID
Follow the re-flashing procedure outlined in
NOTE: The GR8 Battery Charger MUST be used in Power Supply Mode to maintain battery voltage at 13.5 volts while flash reprogramming the vehicle.
For details on how to use the GR8 Battery Charger please refer to the GR8 Instructions Manual located on TIS, Diagnostics-Battery.
NOTE: The vehicle WILL NOT operate properly without this ECU update.
Testing and Evaluation.
Start the engine and let it idle.
Check the fuel system for any leaks.
IMPORTANT: Check the serpentine belt drive systems for correct alignment on ALL pulleys.
Check the coolant system for any leaks.
Set the A/C system as follows:
Any setting except OFF
Page 42 of 45 pages