X hits on this document

204 views

0 shares

0 downloads

0 comments

5 / 45

TOYOTA Procedure

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality installation.

These guidelines can be found in the "Accessory Installation Practices" document.

12 mm Wrench

This document covers such items as:-

! ! ! ! !

Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).

Safety (eye protection, rechecking torque procedure, etc.).

12 mm Wrench

Vehicle Disassembly/Reassembly (panel removal, part storage, etc.). Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.). The TIS Repair Manual can be referenced for additional details.

Please see your Toyota dealer for a copy of this document.

  • 1.

    Installation Review and Vehicle Preparation.

    • (a)

      Review the entire instruction instructions provided before beginning the installation

    • (b)

      Review the parts list/kit contents to ensure that all parts are present before beginning the installation. If any items are missing contact Technical Support at (800) 688-5912 before proceeding.

    • (c)

      Remove any low-octane fuel from the vehicle. Ensure that ONLY 91 octane or higher unleaded gasoline is used.

    • (d)

      Place the vehicle onto vehicle hoist.

    • (e)

      Protect the vehicle with protection blankets over the fenders and front of the vehicle.

Issue: B

10/20/07

  • (f)

    Disconnect and remove the battery.

  • (g)

    When draining the cooling system into a clean container in Step 7, save this coolant as it will be reused. CAUTION: To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause the hot engine coolant and steam to blow out from the radiator.

  • (h)

    All parts that are removed and not reused should be saved for the customer, i.e., “discard” means to save for the customer.

Page 5 of 45 pages

Document info
Document views204
Page views205
Page last viewedThu Jan 19 17:14:27 UTC 2017
Pages45
Paragraphs1344
Words8482

Comments