X hits on this document

142 views

0 shares

0 downloads

0 comments

8 / 45

TOYOTA Procedure

Fig 4-3

Fig 4-5

Fig 4-6

Issue: B

10/20/07

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

(b) Disconnect the ventilation hose (Figs. 4-1 & 4-3).

(c) Disconnect the 2 VSV connectors. Remove the 3 wire harness clamps and hose clamps (Figs 4-1 & 4-4). HINT: Removing the No. 1 VSV at the rear passenger side of the surge tank makes it easier to get to the clamps.

Fig 4-4

(d) Remove the 3 upper bolts which are used to secure the 2 surge tank stays and throttle body bracket Figs 4-1 & 4-5). Loosen the 2 bolts that hold the brackets to the side of the cylinder head. Remove and discard the bracket attached to the front of the cylinder head.

CAUTION: Before proceeding, make sure there is no dirt or debris on or around the base of the surge tank. If there is, you must remove it so that it will not enter the engine when the surge tank is removed.

(e) Using an 8mm Allen socket, remove the 4 bolts and the 2 nuts with a 12mm socket. Remove the surge tank and gasket (Fig 4-6).

Page 8 of 45 pages

Document info
Document views142
Page views143
Page last viewedSat Dec 03 14:16:05 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments