X hits on this document

149 views

0 shares

0 downloads

0 comments

9 / 45

TOYOTA Procedure

Fig 4-7

Fig 4-8

Fig 5-1

Clamp

Fig 5-2

Fig 5-3

Issue: B

10/20/07

FJ CRUISER

MY – 2007-

SUPERCHARGER FIT KIT

(f) Wipe off the engine surface and apply tape to cover the intake ports (Fig 4-7).

(g) After the ports are taped over, using an E-5 internal Torx socket, remove the 2 studs from the intake manifold (Fig 4-8).

  • 5.

    Fuel Injector Replacement.

    • (a)

      For the No. 1 fuel pipe, remove the fuel pipe clamp. Pinch the tube connector, and pull the fuel pipe out of the connector as shown (Figs 5-1, 5-2, 5-3). Repeat for the No. 2 fuel pipe. NOTICE:

!

!

!

!

!

!

Remove any dirt and foreign objects from the connectors before performing this work. Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tube connector has the O-ring that seals the pipe. Perform this work by hand. Do not use any tools. Do not forcibly bend, twist or turn the nylon tube. Protect the disconnected parts by covering them with a plastic bag after disconnecting them. If the fuel tube connector and pipe are stuck, push and pull to release them.

Page 9 of 45 pages

Document info
Document views149
Page views150
Page last viewedMon Dec 05 04:53:51 UTC 2016
Pages45
Paragraphs1344
Words8482

Comments