X hits on this document

606 views

0 shares

0 downloads

0 comments

100 / 182

REASSEMBLY - AUXILIARY SECTION (9-SPEED AND RT-8608L MODELS)

9. Place the bearing outer spacer against cup and use a soft bar or flanged-end driver to move both parts evenly into bore.

11. Install the auxiliary plate over end of output shaft assembly. Heat the rear bearing cone and install on shaft, taper down and inside bearing cup. NOTE: DO NOT HEAT BEARING ABOVE 275oF (136oC).

    • 12.

      If previously removed, install the oil seal in rear bearing cover with a flanged driver (inset). SeaI should be installed so the spring is to the front of transmission.

  • 10.

    Place the rear bearing cup against spacer. Use a flanged-end driver to move all three parts evenly into bore until lip of rear bearing cup seats on auxiliary plate.

Document info
Document views606
Page views606
Page last viewedFri Jan 20 08:29:16 UTC 2017
Pages182
Paragraphs2411
Words25289

Comments