X hits on this document

585 views

0 shares

0 downloads

0 comments

101 / 182

REASSEMBLY - AUXILIARY SECTION (9-SPEED AND RT-8608L MODELS)

  • 13.

    Remount the assembly upright in vise and secure on flange of auxiliary plate. Position the corre- sponding new gasket on cover mounting surface and install the rear bearing cover. Use the nylon collar and brass washer with capscrew at the chamfered hole which intersects speedometer bore (inset} Tighten the capscrews to secure cover to auxiliary plate. NOTE: Because the collar becomes distorted when compressed, DO NOT RE-USE OLD NYLON COLLAR.

    • B.

      Reassembly and Installation of Synchronizer Assembly

2. Install the three springs in bores of high range synchronizer ring.

3. Place the high range synchronizer ring over blocker pins of low range synchronizer, seating the springs against pins.

1. Place the larger low range synchronizer ring on bench and install the sliding clutch on blocker pins, recessed side up.

Document info
Document views585
Page views585
Page last viewedThu Jan 19 04:52:28 UTC 2017
Pages182
Paragraphs2411
Words25289

Comments