X hits on this document

518 views

0 shares

0 downloads

0 comments

104 / 182

REASSEMBLY - AUXILIARY SECTION (9-SPEED AND RT-8608L MODELS)

D. Reassembly and Installation of Range Cylinder Assembly

1. If previously removed, install the O-ring in bore o range cylinder housing.

f

3. Place the range yoke into position with sliding clutch of synchronizer assembly, long hub of yoke to the front (RT-11609/12609 Series); long hub of yoke to the rear (RT-14609 Series). Insert threaded-end of yoke bar through yoke and into bore of range cylinder housing, aligning the notches in bar with yoke Iockscrew holes (inset).

2. Position the corresponding new gasket on hous- ing mounting surface and install the cylinder housing in rear bore of auxiliary plate, air fitting to the upper left. Secure housing to plate with capscrews tightened to recommended torque rat- ings.

4. Install the two yoke Iockscrews, tighten and wire securely.

Document info
Document views518
Page views518
Page last viewedSat Dec 10 22:45:27 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments