X hits on this document

694 views

0 shares

0 downloads

0 comments

120 / 182

DISASSEMBLY - AUXILIARY SECTION (13-SPEED MODELS)

  • 3.

    Using the front face of splitter gear as a base, press the output shaft through the bearing, washer and gear. DO NOT DAMAGE MAINSHAFT QUILL. If necessary, remove the snap ring from

    • I.

      D. of splitter gear (inset).

5. Remove the two bearing cups and outer spacer from housing bore.

4. Turn out the retaining capscrews and remove the rear bearing cover and gasket from auxiliary housing. The rear bearing cone will drop from housing bore when cover is removed. If neces- sary, remove the oil seal from cover (inset).

Document info
Document views694
Page views694
Page last viewedTue Jan 24 01:03:38 UTC 2017
Pages182
Paragraphs2411
Words25289

Comments