X hits on this document

359 views

0 shares

0 downloads

0 comments

122 / 182

REASSEMBLY - AUXILIARY SECTION (13-SPEED MODELS)

B. Reassembly and Installation of Output Shaft and Rear Bearing Assemblies

1. Remount the output shaft in vise with threaded- end up and secure on range mainshaft. Install the stepped washer on shaft, flat side down.

3. IMPORTANT: For timing purposes, mark any two adjacent teeth on splitter gear and repeat the pro- cedure for the two adjacent teeth directly oppo- site the first set marked. A highly visible color of toolmakers' dye is recommended.

2. Install the splined spacer and output shaft against washer, shoulder up.

4. If previously removed, install the snap ring in splitter gear (inset). Install the gear on output shaft, snap ring up and clutching teeth engaged with splines of spacer.

Document info
Document views359
Page views359
Page last viewedSat Dec 03 03:08:05 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments