X hits on this document

422 views

0 shares

0 downloads

0 comments

123 / 182

REASSEMBLY - AUXILIARY SECTION (13-SPEED MODELS)

5. Install the stepped washer on shaft against gear, flat side up.

7. Install the bearing inner spacer on output shaft.

6. Heat the front bearing cone and install on output shaft against washer, bearing taper up. NOTE: DO NOT HEAT BEARING ABOVE 275oF (136oC). If possible, use heat lamps as source.

8. Place the front bearing cup in housing bore, taper to the inside, and use a soft bar to start cup into bore.

Document info
Document views422
Page views422
Page last viewedMon Dec 05 17:23:32 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments