X hits on this document

474 views

0 shares

0 downloads

0 comments

124 / 182

REASSEMBLY - AUXILIARY SECTION (13-SPEED MODELS)

,

9. Stack the bearing outer spacer and rear bearing cup on top of front bearing cup in proper se- quence. Use a flanged-end driver to move all three parts evenly into bore until lip of rear bearing cup seats on housing.

11. Heat the rear bearing cone and install on shaft, taper down and inside cup. Make sure the lip of rear bearing cup is fully seated on housing with bearing installed. NOTE: DO NOT HEAT BEARING ABOVE 275oF (136oC).

  • 10.

    Install the auxiliary housing over end of output shaft assembly, seating the front bearing cone on shaft in cup.

    • 12.

      If previously removed, install the oil seal in rear bearing cover. Seal should be installed so the spring is to the front of cover (inset).

Document info
Document views474
Page views474
Page last viewedThu Dec 08 12:26:41 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments