X hits on this document

517 views

0 shares

0 downloads

0 comments

125 / 182

REASSEMBLY - AUXILIARY SECTION (13-SPEED MODELS)

13. Position the corresponding new gasket on cover mounting surface and install the rear bearing cover on auxiliary housing. Use the nylon collar and brass washer with capscrew at the cham- fered hole which intersects speedometer bore (in- set). Tighten the capscrews to secure cover to housing. NOTE: Because the collar becomes distorted when compressed, DO NOT REUSE OLD NYLON COLLAR.

Document info
Document views517
Page views517
Page last viewedSat Dec 10 22:44:31 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments