X hits on this document

419 views

0 shares

0 downloads

0 comments

126 / 182

REASSEMBLY - AUXILIARY SECTION (13-SPEED MODELS)

C. Timing and Installation of Auxiliary Countershaft Assemblies

NOTE: The auxiliary countershaft assemblies CANNOT be installed in housing with prior instal- lation of the splitter shift yoke.

    • 3.

      Place the left countershaft assembly into posi- tion in housing and mesh the marked tooth of countershaft splitter gear with either set of two marked teeth of splitter gear on output shaft. DO NOT INSTALL REAR BEARING AT THIS TIME.

  • 1.

    If previously removed, install the bearing inner race on front of each countershaft.

2. On the splitter gear of each assembly, use a highly visible color of toolmakers' dye to mark the tooth stamped with an "O" for timing pur- poses.

4. Repeat the previous procedure with the right countershaft assembly, meshing the marked tooth of countershaft splitter gear with the re- maining set of two marked teeth of splitter gear on output shaft. DO NOT INSTALL REAR BEARING AT THIS TIME.

Document info
Document views419
Page views419
Page last viewedMon Dec 05 16:49:31 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments