X hits on this document

466 views

0 shares

0 downloads

0 comments

127 / 182

REASSEMBLY-AUXILIARY SECTION (13-SPEED MODELS)

D. Reassembly and Installation of Splitter Cylinder Assembly

3. If previously removed, install the O-ring in O.D. groove of yoke bar piston.

1. Install the splitter sliding clutch on output shaft, internal splines toward gear and engaged with splines of shaft (inset). Place the splitter shift yoke into position with sliding clutch on output shaft, yoke hub to the front of housing.

4. From the rear of housing, insert the yoke bar through cylinder bore and into shift yoke, align- ing the notch in bar with Iockscrew hole in yoke hub.

2. If previously removed, install the small O-ring in bore of cylinder housing (inset). Position the cor- responding new gasket on housing mounting sur- face and install the splitter cylinder housing in rear bore of auxiliary housing, air channel to the right.

Document info
Document views466
Page views466
Page last viewedThu Dec 08 00:57:40 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments