X hits on this document

420 views

0 shares

0 downloads

0 comments

128 / 182

REASSEMBLY-AUXILIARY SECTION (13-SPEED MODELS)

5. Install the yoke lockscrew, tighten and wire se- curely.

  • 7.

    Position the corresponding new gasket on cover mounting surface and install the splitter cylinder cover on cylinder housing, exhaust port down. in- stall the capscrews in cover and tighten to secure the assembly on auxiliary housing. NOTE: With the cover installed in this manner, the air channel of cover will align with that of cyl- inder housing.

    • E.

      Installation of Low Range Gear

6. If previously removed, install the insert valve in bottom bore of cylinder cover, flat end to the in- side (left). Install the valve retaining nut in ex- haust port of cover and tighten to recommended torque ratings (right). NOTE: Prior to installation of insert valve, make sure the three O-rings on valve O.D. are not defec- tive. Replace, if necessary.

1. Install the snap ring in groove of range mainshaft (inset). Install the coupler on range mainshaft against snap ring, clutching teeth to the rear.

Document info
Document views420
Page views420
Page last viewedMon Dec 05 16:58:08 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments