X hits on this document

523 views

0 shares

0 downloads

0 comments

132 / 182

REASSEMBLY - AUXILIARY SECTION (13-SPEED MODELS)

H. Reassembly and Installation of Range Cylinder Assembly

1. If previously removed, install the O-ring in bore of range cylinder housing.

3. Place the range yoke into position with sliding clutch of synchronizer assembly, long hub of yoke to the rear. Insert threaded-end of yoke bar through yoke and into bore of range cylinder housing, aligning the notches in bar with yoke lockscrew holes.

2.

Position the corresponding new gasket on hous- ing mounting surface and install the cylinder housing in rear bore of auxiliary housing, air fit- ting to the upper left. Tighten capscrews to se- cure cylinder housing to auxiliary housing.

4. Install the two yoke lockscrews, tighten and wire securely.

Document info
Document views523
Page views523
Page last viewedSun Dec 11 05:14:24 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments