X hits on this document

448 views

0 shares

0 downloads

0 comments

134 / 182

DISASSEMBLY - FRONT SECTION

A. Removal of Front Bearing Cover and Input Shaft Nut

1. Turn out the retaining capscrews and remove the drivegear bearing cover and gasket.

3. Engage two mainshaft sliding clutches into gear, this prevents transmission from rotating. Remove nut (left hand thread) with drive gear nut remov- ing tool.

2. If necessary remove the oil seal from cover of models so equipped.

Document info
Document views448
Page views448
Page last viewedWed Dec 07 08:56:46 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments