X hits on this document

478 views

0 shares

0 downloads

0 comments

139 / 182

DISASSEMBLYÑ FRONT SECTION

D. Removal of Countershaft Bearings

NOTE: In the following instructions, the front and rear bearings from BOTH countershaft are re- moved. For removal of the mainshaft assembly from case, it is necessary to remove the bearings from right countershaft ONLY.

2. From inside the case, use a soft punch and maul to drive the countershaft rear bearings to the rear and from case bores. NOTE: This procedure will damage the bearings and should not be attempted unless replacement of the bearings is planned.

1. Remove the snap ring from groove at rear of each countershaft.

Document info
Document views478
Page views478
Page last viewedThu Dec 08 14:43:11 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments