X hits on this document

458 views

0 shares

0 downloads

0 comments

142 / 182

DISASSEMBLY - FRONT SECTION

3. Remove the snap ring from groove at rear of mainshaft.

5. From rear of mainshaft, pull the key from main- shaft keyway. NOTE: When removing limit washers, spacers and gears, note their location on mainshaft to fa- cilitate reassembly. Keep the internal-splined washers and external-splined spacers with the gear from which they were removed. There is ONLY one limit washer and one spacer belonging to each gear.

4. Remove the reverse gear and spacer from rear of mainshaft.

6. Turn the reverse gear limit washer to align its splines with those of mainshaft and remove washer.

Document info
Document views458
Page views458
Page last viewedWed Dec 07 16:46:33 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments