X hits on this document

366 views

0 shares

0 downloads

0 comments

143 / 182

DISASSEMBLY - FRONT SECTION

  • 7.

    Remove the LO-Reverse speed sliding clutch from mainshaft.

    • 9.

      Pull the LO speed gear from rear of mainshaft to remove limit washer, spacer and gear. If neces- sary, remove the snap ring from I.D. of gear (in- set).

8. Using a small screwdriver, turn the limit washer in hub of LO speed gear to align its splines with those of the mainshaft.

10. Remove each remaining gear, limit washer, spacer and sliding clutch from mainshaft in the same manner previously detailed. And, if necessary, re- move the snap ring from I.D. of each gear.

Document info
Document views366
Page views366
Page last viewedSat Dec 03 13:38:22 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments