X hits on this document

399 views

0 shares

0 downloads

0 comments

148 / 182

REASSEMBLY - FRONT SECTION

CASE ASSEMBLIES

NOTE: Before starting reassembly, make sure the three magnetic discs are solidly in place at bottom of case. These can be secured to disc mounting sur- faces with Scotch Grip Rubber Adhesive or equiva- lent adhesive.

A. Reassembly and Installation of Right Reverse Idler Gear Assembly

3. Install the bearing inner race on idler shaft and in- sert shaft into case bore, threaded-end of shaft to the front. As the idler shaft is moved forward, in- stall the reverse idler gear on shaft, long hub to the front and seating on bearing inner race. Posi- tion the thrust washer on shaft between the gear and support boss in case and continue with movement of idler shaft forward into bore of sup- port boss.

1. If previously removed, thread pipe plug in rear of reverse idler shaft and tighten. Install the idler plate on shaft, flat side to the front (inset).

4. Making sure that the reverse idler shaft is seated in bore of support boss and forward as far as pos- sible, install the washer and stop nut on front of shaft. Tighten nut to recommended torque rating.

2. If previously removed, press the needle bearing into bore of reverse idler gear.

Document info
Document views399
Page views399
Page last viewedSun Dec 04 23:52:46 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments