X hits on this document

486 views

0 shares

0 downloads

0 comments

155 / 182

REASSEMBLY - FRONT SECTION

5. Tap the bearing into position in the bore with a soft mallet.

  • 7.

    Use a soft bar and maul to drive the input shaft through bearing. Remove front bearing cover.

    • F.

      Reassembly of Auxiliary Drive Gear Assembly

NOTE: Because the auxiliary drive gear assembly is used in checking reverse gear axial clearances and centering mainshaft in rear bearing bore during Reassembly and Partial Installation of Mainshaft Assembly, it is necessary to complete the following instructions BEFORE proceeding to Part G.

6. Temporarily install the front bearing cover,

1. If previously removed, install the O-rings on ex- tended front hub of auxiliary drive gear.

Document info
Document views486
Page views486
Page last viewedFri Dec 09 06:32:15 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments