X hits on this document

372 views

0 shares

0 downloads

0 comments

157 / 182

REASSEMBLY - FRONT SECTION

  • 4.

    Install the spacer on shaft against washer.

  • 2.

    Secure the mainshaft in a vise equipped with

brass jaws or wood blocks, pilot-end of shaft down. If previously removed, install the roll pin in keyway.

3. Install the 3rd speed gear limit washer on main- shaft, flat side of washer up. Rotate washer in the 1st or bottom groove of mainshaft to align the splines of washer with those of the mainshaft. in- stall the key in mainshaft keyway to lock washer in place.

5. Install the 3rd speed (or Overdrive) gear on main- shaft, clutching teeth down and engaged with ex- ternal splines of spacer. NOTE: Gear limit washers are internally splined and locked to mainshaft by the key. Gear spacers are externally splined to engage with clutching teeth in gear hubs. There is one limit washer and one spacer for each gear in the mainshaft as- sembly.

Document info
Document views372
Page views372
Page last viewedSat Dec 03 20:15:15 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments