X hits on this document

390 views

0 shares

0 downloads

0 comments

159 / 182

REASSEMBLY - FRONT SECTION

10. Install the 1st-2nd speed sliding clutch, aligning the missing internal spline of sliding clutch with key in mainshaft.

9.

Insert two large screwdrivers between the 2nd

and 3rd speed (or Overdrive) gears to check axial clearances. Apply slight downward pressure on screwdriver handles to spread gears evenly. Mak-

ing sure the gear hubs gage between hubs. should be from .005" to

are parallel, insert a feeler Correct axial clearance

.012".

If

the

clearance

is

less than the minimum .005" tolerance, the limit washer in the 2nd speed gear should be replaced by a thinner limit washer. This will increase the axial clearance between the gears. If the clear- ance checked is greater than the maximum .012"

tolerance,

a thicker limit

stalled in

the 2nd speed

crease the

axial clearance

washer should be in- gear. This would de- between the gears.

11. Remove the key from keyway and install the 1st speed gear limit washer on mainshaft, flat side of washer up. Rotate washer in the 2nd groove of mainshaft to align the splines of washer with those of the mainshaft and reinsert key in keyway to lock washer in place.

Document info
Document views390
Page views390
Page last viewedSun Dec 04 08:29:59 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments