X hits on this document

383 views

0 shares

0 downloads

0 comments

160 / 182

REASSEMBLY—FRONT SECTION

SETTING CORRECT AXIAL CLEARANCES FOR MAINSHAFT GEARS

Axial Clearance (End-Play) Limits Are: .005’’ -,012” for all mainshaft gears

LIMITS (INCH)

COLOR CODE

.248 -.250

WHITE

.273 -.275

BLACK

*

“PLUS RED”

Washers are used to obtain the correct limits; six thicknesses are available as follows:

.253 -.255

GREEN

.258 -.260

ORANGE

.263 -.265

PURPLE

.268-.270

YELLOW

*NOTE: New style limit washers come in a full range of tolerances as corresponding colors listed above “plus red.” (Example: “Orange plus red” limit washer has an inch limit thickness of .258 -.260.)

Refer to Illustrated Parts Lists for washer part num- bers.

Always use the .248-.250” low limit washer (’(White” or “white plUS red”) in the 1st and 3rd speed gear Do- sitions as’ shown at right.

IMPORTANT: REFER TO THE APPROPRIATE iL- LUSTRATED PARTS LIST (SPECI- FIED BY MODEL SERIES) TO ENSURE THAT PROPER PARTS ARE USED DURING REASSEMBLY OF THE TRANSMISSION.

Document info
Document views383
Page views383
Page last viewedSun Dec 04 06:35:56 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments