X hits on this document

519 views

0 shares

0 downloads

0 comments

166 / 182

REASSEMBLY-FRONT SECTION

  • 28.

    Remove the mainshaft assembly from vise. Align the missing internal spline of 3rd-4th speed slid- ing clutch with key in mainshaft and install on front of shaft, engaging the external splines of sliding clutch with clutching teeth of 3rd speed (or Overdrive) gear.

    • 30.

      Move the pilot-end of mainshaft into pocket bush- ing of input shaft.

29. Block the right countershaft assembly against case wall and lower the mainshaft assembly into position with the reverse gear held against LO speed gear and rear of shaft moved into case bore.

Document info
Document views519
Page views519
Page last viewedSat Dec 10 23:18:29 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments