X hits on this document

520 views

0 shares

0 downloads

0 comments

168 / 182

REASSEMBLY - FRONT-SECTION

  • 2.

    Insert countershaft support tool or blocking in rear bearing bore.

  • 3.

    Install the right countershaft bearings in the same manner described in Part D for left coun- tershaft bearings.

    • 5.

      Move the reverse gear to the rear on mainshaft and use a screwdriver to engage sliding clutches with all forward speed gears. A sliding clutch that will not engage with a gear indicates the gear set is not in proper mesh. The bearings of the right countershaft would then need to be removed and the drive gear set retimed. NOTE: Do not engage sliding clutches with more than one gear at the same time. This will lock the gearing and prevent the mainshaft and countershaft assemblies from rotating.

    • 1.

      Reassembly and Installation of Left Reverse Idler Gear Assembly NOTE: Since the left and right reverse idler gear assemblies are identical, reassembly and installa- tion of the left reverse idler gear assembly should be performed at this time as described in Part A of this section.

4. With bearing installation complete, install the snap ring in groove at rear of right countershaft.

Document info
Document views520
Page views520
Page last viewedSat Dec 10 23:25:52 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments