X hits on this document

623 views

0 shares

0 downloads

0 comments

169 / 182

REASSEMBLY - FRONT SECTION

J. Completed Installation of Mainshaft and Auxiliary Drive Gear Assemblies

1. Remove the auxiliary drive gear assembly from mainshaft and rear bearing bore. Do not allow mainshaft to move to rear when removing aux- iliary drive gear.

3. Align the external splines of spacer with clutch- ing teeth of reverse gear and move spacer forward on mainshaft and into gear.

4. Install the snap ring in hub of reverse gear and move the reverse gear forward on mainshaft and into proper position in case.

2. Move the reverse gear to the rear as far as possi- ble, meshing teeth of gear with those of the re- verse idler gears.

Document info
Document views623
Page views623
Page last viewedSat Jan 21 04:22:50 UTC 2017
Pages182
Paragraphs2411
Words25289

Comments